VTSYIQI Digital Shore A Hardness Tester Meter Shore A Durometer 0 to 100HA for Leather Wax Rubber Polygrease Handhold Rubber Durometer

• Specification:
• Measuring range : 0-100HA This apparatus has three models of Type A, Type C and Type D.
• Recommended Measuring range : 10-90HA This hardness gauge conforms to the regulations of GB/T531,GB2411, HG/T2489, JB6148.
• Outline dimension : 115x60x25mm Type A and D respectively are applicable to the testing of low and medium hardness, and high-hardness materials.
• Pressure Needle Range : 2.5mm Digital shaw rubber hardness tester is an apparatus to measure vulcanized rubber and plastic products.
• End pressure of Pressure Head:Type A and C :0.55N-8.05N Type D:0-44.5N Type C applies to the testing of microporous material which is used to make shoes, with compression rate 50 percent, stress 0.049 MPa or above, and this kind of material is made of rubber plastic and has blister in plastic.

VTSYIQI Digital Shore Durometer Shore Hardness Tester 0 to 100HA for Leather Wax Rubber Polygrease Handhold Rubber Durometer

Specification:

When using single pointer models, one should place the sample in the solid plane, hold the hardness gauge, keep the pressure needle at a distance of at least 12 mm from the edge of the sample, smooth enough pressure in the pressure on the sample, and smoothly press on the sample to a full extent.

One should press the pressure needle vertically to the sample, and until pressed to a full extent and contact the sample completely, then read the calibration value within one second.

At measuring points which are at least 6 mm away from each other, measure hardness values for five times, and calculate the average value(for microporous material, the distance between the measuring points should be at least 15 mm). In order to keep the stability of conditions and improve the accuracy of determination, one should install the hardness gauge on the same type of the measuring shelf from a complete production network. When using double pointer models to do measurement, one should rotate the supporting pointer to the wax, etc.

​ Technical Parameters:

1: Measuring range : 0-100HA

2: Recommended Measuring range : 10-90HA

3: Outline dimension : 115x60x25mm

5: Pressure Needle Range : 2.5mm

6:End pressure of Pressure Head:Type A and C :0.55N-8.05N Type D:0-44.5N